Manages and inserts content such as blocks, xrefs, and hatch patterns

Creates a region or a polyline from an enclosed area

Draws filled circles and rings

Controls the filling of objects such as hatches, two-dimensional solids, and wide polylines

Shows values of specified system registry variables

Modifies an existing hatch or fill

Applies the properties of a selected object to other objects

Creates two-dimensional polylines

Controls properties of existing objects

Sets values of specified registry variables

Creates solid-filled triangles and quadrilaterals

Manages user coordinate systems

Specifies whether hatches and fills, two-dimensional solids, and wide polylines are filled in

Specifies the hatch pattern angle

Controls whether hatch patterns and gradient fills are associative

Controls the object type created by the BHATCH and BOUNDARY commands

Controls the draw order of hatches and fills

Specifies hatch pattern doubling for user-defined patterns

Treats a set of objects that almost enclose an area as a closed hatch boundary

Controls the hatch origin of the resulting hatch when using Inherit Properties in HATCH and HATCHEDIT

Controls the draw order of hatches and fills

Sets a default hatch pattern name of up to 34 characters without spaces

Sets the number of hatch boundary objects that can be selected before displaying a warning message

Controls the hatch origin of the resulting hatch when using Inherit Properties in HATCH and HATCHEDIT

Sets the hatch origin point for new hatch objects relative to the current user coordinate system

Controls how HATCH determines the default hatch origin point

Specifies the hatch pattern scale factor, which must be greater than zero

Controls whether HATCH creates a single hatch object or separate hatch objects when operating on several closed boundaries

Specifies the hatch pattern line spacing for user-defined simple patterns, which must be greater than zero

Controls the use of group selection and associative hatch selection