Use a Flip Action in a Dynamic Block

Up a level to ..

Use a Lookup Action in a Dynamic Block

 

AutoCAD 2008 User's Guide > Create and Modify Objects > Create and Use Blocks (Symbols) > Add Dynamic Behavior to Blocks > Add Dynamic Elements to Blocks > Use Actions with Dynamic Blocks > Use an Array Action in a Dynamic Block > 

Use an Array Action in a Dynamic Block

Concept

Procedure

Quick Reference

To add an array action a block definition

1. In the Block Editor, in the Block Authoring Palettes window, Actions tab, click the Array Action tool.
2. In the Block Editor drawing area, select a parameter to associate with the action. (You can associate linear, polar, and XY parameters with an array action.)
3. Select the objects (the selection set) to associate with the action.
4. Press ENTER.
5. If you are associating the array action with an XY parameter, do one of the following:
   • Enter the distance between rows.
   • Specify a unit cell by entering two values separated by a comma or by picking two opposite points of a rectangle in the drawing area, and then go to step 7.
6. Enter a value for the distance between columns.
7. If you are assigning the array action to an XY parameter, enter the distance between rows.
8. Do one of the following to specify the location of the action:
   • Use the pointing device.
   • Enter the X and Y coordinate values, separated by a comma.
     NoteThe action location in the block definition has no effect on the appearance or functionality of the block reference.
9. On the Block Editor toolbar, click Save Block Definition.
10. If you are finished using the Block Editor, click Close Block Editor.

 Toolbar: Block Editor 

 Command entry: BACTION