Use a Move Action in a Dynamic Block
 
 
 
508 Resource Limit Is Reached

Resource Limit Is Reached

The website is temporarily unable to service your request as it exceeded resource limit. Please try again later.

To add a move action to a dynamic block definition

  1. In the Block Editor, in the Block Authoring Palettes window, Actions tab, click the Move Action tool.
  2. In the Block Editor drawing area, select a parameter to associate with the action. (You can associate the following parameter types with a move action: point, linear, polar, and XY.)
  3. Select the objects (the selection set) to associate with the action.
  4. Press ENTER.
  5. (Optional) Follow the command prompts to specify a distance multiplier and angle offset.
  6. Do one of the following to specify the location of the action:
    NoteThe action location in the block definition has no effect on the appearance or functionality of the block reference.
  7. On the Block Editor toolbar, click Save Block Definition.
  8. If you are finished using the Block Editor, click Close Block Editor.
 Toolbar: Block Editor 
 Command entry: BACTION