Use Parameters in Dynamic Blocks
 
 
 

To add a visibility parameter to a dynamic block definition

  1. In the Block Editor, in the Block Authoring Palettes window, Parameters tab, click the Visibility Parameter tool.
  2. (Optional) Follow the command prompts to specify the following for the parameter:
    NoteYou can also specify and edit these properties in the Properties palette at a later time, after you've added the parameter to the block definition.
  3. Do one of the following to specify a location for the parameter:

    This is the location for the visibility parameter grip in the block reference.

  4. On the Block Editor toolbar, click Save Block Definition.
  5. If you are finished using the Block Editor, click Close Block Editor.
 Toolbar: Block Editor 
 Command entry: BPARAMETER