Draw Polylines
 
 
 

To create a wide polyline

  1. Click Draw menu Polyline.At the Command prompt, enter pline.
  2. Specify the start point of the line segment.
  3. Enter w (Width).
  4. Enter the starting width of the line segment.
  5. Specify the ending width of the line segment using one of the following methods:
  6. Specify the endpoint of the polyline segment.
  7. Continue specifying segment endpoints as needed.
  8. Press ENTER to end, or enter c to close the polyline.
 Toolbar: Draw 
 Command entry: PLINE