AddDimRadialLarge Method

Creates a jogged radial dimension for an arc, circle, or polyline arc segment.

See Also | Example

Signature

RetVal = object.AddDimRadialLarge(Center, ChordPoint, OverrideCenter, JogPoint, JogAngle As Double)

Object

ModelSpace Collection, PaperSpace Collection, Block
The object or objects this method applies to.

Center

Variant (three-element array of doubles); input-only
The 3D WCS coordinates specifying the center of the arc, circle, or polyline arc segment.

ChordPoint

Variant (three-element array of doubles); input-only
The 3D WCS coordinates specifying the chord point for the arc.

OverrideCenter

Variant (three-element array of doubles); input-only
The 3D WCS coordinates specifying the override center location or pick point.

JogPoint

Variant (three-element array of doubles); input-only
The 3D WCS coordinates specifying the jog location or pick point.

JogAngle

Variant (three-element array of doubles); input-only
The 3D WCS coordinates specifying the jog angle.

RetVal

DimRadialLarge object
The newly created jogged radius dimension.

Remarks

 

The Center is the center of the arc, circle, or polyline arc segment being dimensioned. The OverrideCenter is the origin point of the dimension.

Note To access this method, use the AcadBlock, AcadModelSpace, or AcadPaperSpace interface.

 

   Comments?