Specify Value Sets for Dynamic Blocks
 
 
 

To specify a value set for a rotation parameter

  1. In the Block Editor, click Tools menu Properties. The Properties palette is displayed.
  2. In the Block Editor, select a rotation parameter.
  3. In the Properties palette, under Value Set, click Ang Type.
  4. On the drop-down list, select List.
  5. In the Properties palette, under Value Set, click Ang Value List.
  6. Click the [...] button.
  7. In the Add Angle Value dialog box, under Angle to Add, enter one value or two or more values separated by commas.
  8. Click Add.
  9. Click OK.
  10. On the Block Editor toolbar, click Save Block Definition.
  11. (Optional) If you are finished using the Block Editor, click Close Block Editor.
 Toolbar: Standard 
 Command entry: PROPERTIES