Overview of Using Lookup Tables to Assign Data to Dynamic Blocks
 
 
 

To create a lookup table for a dynamic block

  1. In the Block Editor, add one or more lookup parameters to a dynamic block definition by following the steps in To add a lookup parameter to a dynamic block definition.
  2. In the Block Editor, add a lookup action to a dynamic block definition by following the steps in To add a lookup action to a dynamic block definition.

    The Property Lookup Table dialog box is displayed.

  3. Use any of the following procedures to set up a lookup table for the dynamic block:
  4. On the Block Editor toolbar, click Save Block Definition.
  5. (Optional) If you are finished using the Block Editor, click Close Block Editor.
 Toolbar: Block Editor 
 Command entry: BPARAMETER

500 Internal Server Error

Internal Server Error

The server encountered an internal error or misconfiguration and was unable to complete your request.

Please contact the server administrator at webmaster@entercad.forsenergy.ru to inform them of the time this error occurred, and the actions you performed just before this error.

More information about this error may be available in the server error log.

Additionally, a 500 Internal Server Error error was encountered while trying to use an ErrorDocument to handle the request.