Use Parameters in Dynamic Blocks

Up a level to ..

Use Parameters in Dynamic Blocks

 

AutoCAD 2008 User's Guide > Create and Modify Objects > Create and Use Blocks (Symbols) > Add Dynamic Behavior to Blocks > Add Dynamic Elements to Blocks > Use Parameters in Dynamic Blocks > 

Use Parameters in Dynamic Blocks

Concept

Procedure

Quick Reference

To add an alignment parameter to a dynamic block definition

1. In the Block Editor, in the Block Authoring Palettes window, Parameters tab, click the Alignment Parameter tool.
2. Follow the command prompts to specify the parameter name.
3. Do one of the following to specify the base point of the alignment parameter:
   • Use the pointing device.
   • Enter the X and Y coordinate values, separated by a comma.

   This base point is the default location for the alignment parameter grip.

4. (Optional) Enter type at the command prompt and follow the prompts to specify whether the parameter type is perpendicular or tangent.
5. Do one of the following to specify the alignment direction:
   • Use the pointing device.
   • Enter the X and Y coordinate values, separated by a comma.
6. On the Block Editor toolbar, click Save Block Definition.
7. If you are finished using the Block Editor, click Close Block Editor.

 Toolbar: Block Editor 

 Command entry: BPARAMETER