Use Parameters in Dynamic Blocks

Up a level to ..

Use Parameters in Dynamic Blocks

 

AutoCAD 2008 User's Guide > Create and Modify Objects > Create and Use Blocks (Symbols) > Add Dynamic Behavior to Blocks > Add Dynamic Elements to Blocks > Use Parameters in Dynamic Blocks > 

Use Parameters in Dynamic Blocks

Concept

Procedure

Quick Reference

To add a linear parameter to a dynamic block definition

1. In the Block Editor, in the Block Authoring Palettes window, Parameters tab, click the Linear Parameter tool.
2. (Optional) Follow the command prompts to specify the following for the parameter:
   • Name
   • Label
   • Description
   • Value set
   • Chained Actions
   • Properties displayed for block reference
   NoteYou can also specify and edit these properties in the Properties palette at a later time, after you've added the parameter to the block definition.
3. Do one of the following to specify a base point for the parameter:
   • Use the pointing device.
   • Enter the X and Y coordinate values, separated by a comma.
4. Do one of the following to specify an endpoint for the parameter:
   • Use the pointing device.
   • Enter the X and Y coordinate values, separated by a comma.
5. Do one of the following to specify a location for the parameter label:
   • Use the pointing device.
   • Enter the X and Y coordinate values, separated by a comma.

     The yellow alert icon indicates that you should associate an action with the parameter you just added.

6. To add an action now, double-click the alert icon. Follow the prompts to associate an action with the parameter and a selection set of geometry.
7. On the Block Editor toolbar, click Save Block Definition.
8. If you are finished using the Block Editor, click Close Block Editor.

 Toolbar: Block Editor 

 Command entry: BPARAMETER