Use i-drop
 
 
 
508 Resource Limit Is Reached

Resource Limit Is Reached

The website is temporarily unable to service your request as it exceeded resource limit. Please try again later.

To specify the default type of i-drop content

  1. At the Command prompt, enter setidrophandler.
  2. In the Set Default i-drop Content Type dialog box, in the Choose Default i-drop Content Type list, select a type of i-drop content.

    The only i-drop content types that are listed are those for installed Autodesk products that provide this type of i-drop functionality.

    If the representative i-drop content image you drag into your drawing points to more than one type of content, this setting specifies which type of content is actually inserted. Selecting Block specifies that a block is inserted. You can drop a block into a drawing that was created in any AutoCAD-based product.


508 Resource Limit Is Reached

Resource Limit Is Reached

The website is temporarily unable to service your request as it exceeded resource limit. Please try again later.